Paradyne 316x manual Setting the IP Address, Com Use Next Snmp Ascii

ACCULINK 316x DSU/CSU

3. Press F1 to select Edit.

Choose Funct:

Edit Save

F1 F2 F3

4.Press the key from the Edit screen to display the User selection.

Edit:

DTE Port NET

F1 F2 F3

5. Press F3 to select User.

Edit:

Chan Gen User

F1 F2 F3

6.Press the F1 (Next) key until the Com Use configuration option appears.

Self-Test:Enab

Next Enab Disab

F1 F2 F3

7.Press F2 to configure the COM port as the management link to an external SNMP manager.

Com Use:

Next SNMP ASCII

F1 F2 F3

Differences Using the Async Terminal: To select the port to be used for SNMP communications, use the main/configuration/edit/user screen to set the Use field to SNMP for the appropriate port type. Figure 3-21 shows an example of this screen.

Customer ID: New Cust	main/configuration/edit/user
	Model: ACCULINK XXXX
	User

Self Test: _____

Front Panel Access: _____
Front Panel Pass-Through: _____
Dial-In Access: _____
Password Mode: _____
Communications Port		Modem Port
Use: _____		Use: _____
Type: _____		Type: _____
Rate: _____		Rate: _____
Character Length: _____	Character Length: _____
Parity: _____
		Parity: _____
Stop Bits: _____		Stop Bits: _____
	Long Space Disconnect: _____
Save Edit Main Previous		Cntrl±x to Disconnect

Figure 3-21. Edit User Screen

Setting the IP Address

The IP address is the address used by the SNMP manager to access the device. For devices using PPP, the IP address can be negotiated, if the network device, e.g., router or SNMP manager, supports such negotiation. The IP address is composed of four fields with three digits per field (xxx.xxx.xxx.xxx).

The IP address is set for either the COM port or the MODEM port, depending on which one has been chosen as the SNMP communications link. The example below assumes that an IP address of 010.155.111.222 is being set for the MODEM port. You can use the same principles to assign any value (between 000 and 255 for each digit field) to either port.

3-26 December 1996 3160-A2-GB22-10