Paradyne 316x Box Contents, Quick Start Procedure, One ACCULINK 3160/3164 DSU/CSU Reference Card

Installation

Box Contents

The 3160/3164 DSU/CSU product arrives in a single box and should contain the following:

•One 3160/3164 DSU/CSU standalone unit

•One 14.5 foot VF cable

•One power transformer

•One ACCULINK 3160/3164 DSU/CSU Reference Card

•One ACCULINK 316x Data Service Unit/Channel Service Unit Operator's Guide

Please refer all servicing to qualified personnel. The Download front panel branch is dedicated to DSU/CSU service and maintenance and is not intended for use by the customer.

The 3100 Series Front Panel Emulation software is available separately and is described in the Front Panel Emulation Software Installation section later in this chapter.

Important Safety Instructions

Read and follow all warning notices and instructions marked on the 316x DSU/CSU or included in this guide.

NOTE

The Download command is for use by service personnel only. Loss of primary data could result from improper use.

HANDLING PRECAUTIONS

FOR

STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact your nearest sales or service representative.

For a complete listing of the safety instructions, see the Important Safety Instructions section earlier in this guide.

Quick Start Procedure

The following procedure is for experienced DSU/CSU users who are familiar with the 3160/3164 DSU/CSU installation process and have no special requirements for their application.

1.Attach the power cord to the rear of the DSU/CSU and the other end to a grounded 115 Vac power outlet.

2.Attach the 3160/3164 DSU/CSU network connection to the T1 network using the appropriate cable. Attach the 3160/3164 DSU/CSU to the CPE via the DTE (DSX-1) and/or ports connectors. Adapter cables are available which allow RS449 or V.35 devices to be supported from the EIA 530A connector on the rear panel. Refer to Appendix H, Equipment List. See the 3160/3164 DSU/CSU Cabling section later in this chapter for more cabling information.

3.Power on the DSU/CSU to perform the power-up self-test. See the Power-UpSelf-Testsection later in this chapter for more information.

4.To perform front panel emulation, connect the cable from the PC to the COM port on the rear panel of the DSU/CSU. To perform device management from an async terminal, connect the terminal to the COM port (or for dial-in access, the modem port) on the rear panel of the DSU/CSU. See the 3160/3164 DSU/CSU Cabling section later in this chapter for more cabling information.

3160-A2-GB22-10 December 1996 2-5