Paradyne 316x manual Health and Status Messages, Description

ACCULINK 316x DSU/CSU

	Table 3-9
	Health and Status Messages
Message	Description
LOS at Net	A Loss Of Signal (LOS) condition (declared after 175 consecutive zeros) has been detected on
	the network interface. The condition is cleared when the density of ones to zeros received is
	12.5%.
LOS at DTE	An LOS condition (declared after 175 consecutive zeros) has been detected on the DSX-1
	interface. The condition is cleared when the density of ones to zeros received is 12.5%.
OOF at Net	An Out Of Frame (OOF) condition (2 out of 4 frame synchronization bits in error) has been
	detected on the network interface. The condition is cleared when a reframe occurs.
OOF at DTE	An Out Of Frame has been detected on the DSX-1 interface. The condition is cleared when a
	reframe occurs.
AIS at Net	An Alarm Indication Signal (unframed all ones signal) is being received by the network interface.
AIS at DTE	An Alarm Indication Signal is being received by the DSX-1 interface.
EER at Net	The error rate of the received network signal exceeds the currently configured threshold (if the
	network is configured for ESF framing). The condition is cleared when the error rate falls below
	the threshold value.
Yellow at Net	A yellow alarm signal is being received by the network interface.
Yellow at DTE	A yellow alarm signal is being received by the DSX-1 interface.
Selftest failed	A failure was detected during the power-on self-test. Select STest under the Stat branch to
	display more information about the failure.
DevFail ########	An internal error has been detected by the operating software. An 8-digit code appears for use
	by service personnel. The condition is cleared by resetting the device.
Download failed	A download attempt was interrupted and failed to complete. The condition is cleared by resetting
	the device.
Alrm Retry Disab	Appears only if an alarm message attempts to exceed the maximum number of alarm retries.
Test in progress	A test is currently active. Select Tstat under the Stat branch to display more information about
	the test.
Modem Connected	The integral modem is currently connected. This message is only displayed for 3160/3164
	DSU/CSUs.
Master Clk fail	The master clock has failed. Timing for the DSU/CSU is provided by the internal clock.
SNMP Link Down	The currently configured SNMP management link is down, allowing no communication between
	the management system and the device. If the management link is configured on the MODEM
	port, the modem must be currently connected for this message to display.

3-54 December 1996 3160-A2-GB22-10