Paradyne 316x Selecting a Model, DSU/CSU Identity, Status DevHS STest Perf, Status TStat LED ID

ACCULINK 316x DSU/CSU

Differences Using the Async Terminal: To monitor the self-test from the async terminal, select Health, Test Status, and Self Test Results from the main/status menu. The full screen display capacity provides a complete test results screen that includes the self-test results.

Figure 2-10 shows an example of this screen.

Customer ID: New Cust		main/status/health_and_status
		Model: ACCULINK XXXX
Health and Status	Self Test Results		Test Status
DSU Operational	CPU fail		No Test Active
LOS at Net	Device fail		LLB Test Active
LOS at DTE	B8ZS/LOS fail		PLB Test Active
OOF at Net	Modem fail		DLB Test Active
OOF at DTE	DTE T1 fail		RLB Test Active
AIS at Net	Alarm fail		DCLB on Port n
AIS at DTE	LCD fail		DTLB on Port n
EER at Net	NET T1 fail		QRSS Test Active
Yellow at Net	Memory fail		1±8 Test Active
Yellow at DTE	DSU fail		QRSS on Port n
Master Clock Fail	DSU Port 1 fail		511 on Port n
SNMP Link Down	DSU Port 2 fail		Monitoring QRSS
Selftest failed	DSU Port 3 fail		Monitoring QRSS, Port n
DevFail yyyyyyyy	DSU Port 4 fail		Monitoring 511, Port n
Download failed	Unknown Exp Dev		DLB Test, Extrn
Alm Retry Disab	Failure xxxxxxxx		Lamp Test Active
Test in progress	Passed

Modem Connected

Refresh Down UP Main Previous Cntrl±x to Disconnect

Figure 2-10. Health and Status Results Screen

If a test fails, fail appears next to the component reporting the failure.

To perform a power or reset of the device, see Resetting the CSU/DSU in Chapter 4.

Selecting a Model 3161

DSU/CSU

Use the SDCP when accessing a specific circuit card installed in the 3000 Series Carrier.

To access a 3161 DSU/CSU,

1.Press Select on the SDCP.

2.Enter a valid carrier and slot address. The green OK indicator on the selected 3161 DSU/CSU should flash. (It should be the only OK indicator flashing in the cabinet.)

3.Press Select again. The display on the SDCP should show the last menu item displayed, or in the case of a new installation, the top-level menu on the selected circuit card.

DSU/CSU Identity

The identity of the 316x DSU/CSU (serial number, model number, software revision level, hardware revision level, and customer ID) is available through the Status branch of the front panel menu (see Appendix A, Front Panel Menu).

The customer ID is the only identity number you can change.

To display the DSU/CSU's identity,

1.Press F1 to select Status from the top-level menu screen.

DSU ESF

Stat Test Cnfig

F1 F2 F3

2.Press the key three times on the Status screen to bring the ID selection onto the front panel LCD.

Status:
DevHS STest		Perf
F1	F2	F3

3. Press F3 to select ID from the Status screen.

Status:

TStat LED ID

F1 F2 F3

2-10 December 1996 3160-A2-GB22-10