Operation

4.The Start At screen displays the configuration option used to select the starting DS0 channel. If the destination selected is the Network T1 interface, then the Network channels appear on the screen. If the destination selected is the DSX-1 DS-1 Drop/Insert T1 interface, then these channels appear on the screen. The following screen shows an example of the Network T1 interface. Use the or key to scroll the desired channel onto the screen. Use the Function keys to select the starting channel. Only those DS0 channel numbers that provide enough bandwidth (based on the configured data rate) to be used as a starting channel number are displayed.

Start At:Clear

Next Clear N1

F1 F2 F3

Individual Channel Assignment Method Example

The Assign By configuration option screen appears after you select a port. To assign by the individual channel method,

1.Press the key once to bring the Chan selection onto the screen.

Assign By:Block

Next Block ACAMI

F1 F2 F3

2. Press F3 (Chan).

Assign By:Chan

Block ACAMI Chan

F1 F2 F3

3.Press F1 (Next) to display the next configuration option (channel allocation).

Assign By:Chan

Next Block ACAMI

F1 F2 F3

4.Line 1 displays the 24 channels for the Network T1 interface or the DSX-1 Drop/Insert T1 interface, depending on which destination was chosen. This example assumes that the Network T1 interface is the destination. Line 2 displays what is allocated to the DS0 channel shown in

Line 1. Pressing the or key scrolls the channels onto the screen in groups of three. Possible values for Line 2 are listed in Table 3-7. Select the channel by pressing the Function key under the desired number. Portn appears. The port is assigned to that channel. To unallocate a port, press the Function key under that port number. Pressing the Function key under channels assigned to other ports has no effect.

 

N1

N2

Next

Prt1

Prt2

F1

F2

F3

Allocating DS0 Channels from the DSX-1 Drop/Insert T1 Interface to the Network T1 Interface

You can allocate DS0 channels from the DSX-1 Drop/Insert T1 interface to the Network interface and specify which DS0 channels carry Robbed Bit Signaling (RBS) information for voice channels.

To allocate DS0 channels from the DSX-1 Drop/Insert

T1 interface to the Network interface,

1.Press F3 to select Cnfig from the top-level menu screen.

DSU ESF

Stat Test Cnfig

F1 F2 F3

3160-A2-GB22-10

December 1996

3-45

Page 87
Image 87
Paradyne 316x Individual Channel Assignment Method Example, Assign ByChan Block Acami Chan, Assign ByChan Next Block Acami