Paradyne 316x Factory Default Configuration Options, Installing Front Panel Emulation Software

ACCULINK 316x DSU/CSU

Factory Default Configuration Options

The 316x DSU/CSU arrives with two preset factory

default configuration settings. These settings are based on the following:

•Factory 1 ± ESF framing format with B8ZS line coding format for both the network and the DSX-1 Drop/Insert T1 interfaces. Data ports are unassigned.

•Factory 2 ± D4 framing format with AMI line coding format for both the network and the DSX-1 Drop/Insert T1 interfaces. Data ports are unassigned.

If neither of the factory default settings support your network's configuration, you can customize the configuration options to better suit your application. Refer to the Configuring the DSU/CSU section in Chapter 3, Operation, and Appendix C, Configuration Options, for more information.

Installing Front Panel

Emulation Software

The Front Panel Emulation software is supplied on a

3.5-inch diskette formatted as 1.44 Mb, double-sided, high-density, write-protected, with 15 sectors per track, 80 tracks per side, 96 tracks per inch.

This software must be installed on either a 286 or higher PC with Microsoftr Windowst Release 3.1 or higher already installed, and MS-DOSr3.3 or higher. A VGA color monitor with VGA adapter (or higher resolution) is required. A mouse is also required. The following procedures must be performed in the Windows environment.

To install Front Panel Emulation software,

1.Insert the diskette into the appropriate drive.

2.Select File from Program Manager.

3.Choose Run...

4.Type the letter of the drive being used by the diskette, followed by a colon.

5.TYPE: INSTALL

6.PRESS: ENTER

7.An Information screen appears. Choose Continue to continue the installation.

8.Type the letter of the destination drive, followed by a colon (default is C:), then the appropriate directory name (default is C:\FRONTPAN).

If the selected directory already exists, the message The specified directory already exists.

Do you want to overwrite the directory? appears.

If the selected directory is new, the message The specified directory does not exist. Do you want to create the directory? appears.

9.Select Yes. A confirmation screen appears. Select Install to continue the installation.

10.A Setup Completed screen appears. Select Continue. The Program Manager screen appears with the Front Panel icon.

See the Starting Up a Front Panel Emulation section in Chapter 3, Operation, for information about the Front Panel Emulation operation.

2-16 December 1996 3160-A2-GB22-10