Paradyne 316x manual Synchronous Port Table, RS-232-like MIB, Input Signal Table, RS-232-like MIB

ACCULINK 316x DSU/CSU

Asynchronous Port Table, ªrs232AsyncPortStopBitsº (rs232AsyncPortEntry 3)

This object specifies the number of stop bits supported. Only the following values are supported by the DSU/CSU.

•one(1) ± One stop bit.

•two(2) ± Two stop bits.

•one-and-half(3) ± One and a half stop bits.

Asynchronous Port Table, ªrs232AsyncPortParityº (rs232AsyncPortEntry 4)

This object specifies the parity used by the port. Only the following values are supported by the DSU/CSU.

•none(1) ± No parity bit.

•odd(2) ± Odd parity.

•even(3) ± Even parity.

Asynchronous Port Table, ªrs232AsyncPortAutoBaudº (rs232AsyncPortEntry 5)

This object specifies the ability to automatically sense the input speed of the port. Only the following value is supported by the DSU/CSU.

•disabled(2) ± Autobaud is not supported.

Synchronous Port Table, RS-232-like MIB

The synchronous port table contains an entry for each of the synchronous DCE data ports and the MODEM or COM port when the port is configured for synchronous operation. For the T1 DSU/CSU, the entries in the table that are counters (rs232SyncPortEntry 3±7) are used to collect statistics and are not supported.

Synchronous Port Table ± ªrs232SyncPortClockSourceº (rs232SyncPortEntry 2)

This object specifies the clock source for the port. Only the following values are supported by the DSU/CSU.

•internal(1) ± The port uses an internal clock.

•external(2) ± The port uses an external clock.

Input Signal Table, RS-232-like MIB

This table contains entries for the input signals that can be detected by the unit for each of the synchronous DCE data ports.

Input Signal Table ± ªrs232InSigNameº (rs232InSigEntry 2)

This object contains the identification of a hardware input signal. Only the following values are supported by the DSU/CSU.

•rts(1) ± Request-To-Send

•dtr(4) ± Data Terminal Ready

Input Signal Table ± ªrs232InSigStateº (rs232InSigEntry 3)

This object contains the current signal state. Only the following values are supported by the DSU/CSU.

•on(2) ± The signal is asserted.

•off(3) ± The signal is not asserted.

Input Signal Table ± ªrs232InSigChangesº (rs232InSigEntry 4)

This object is not supported by the T1 DSU/CSU.

Output Signal Table, RS-232-like MIB

This object contains entries for the output signals that can be asserted by the unit for each of the synchronous DCE data ports.

E-12 December 1996 3160-A2-GB22-10