Tektronix 071-0855-05 user manual SOURceDATASECTionTRACeVALUeSTRIng, SOURceDATASOURce

Reference: Remote Commands ~ Command Description

:SOURce:DATA:SECTion:TRACe:VALUe

This command sets the data byte values transmitted in the Section Trace (J0) byte of the Transport Overhead. The data bytes are formatted as a standard IEEE-488 data block. The query form returns the current values.

Syntax :SOURce<slot>:DATA:SECTion:TRACe:VALUe? :SOURce<slot>:DATA:SECTion:TRACe:VALUe <Block>

:SOURce:DATA:SECTion:TRACe:VALUe:STRIng

This command sets the data byte values transmitted in the Section Trace (J0) byte of the Transport Overhead. The data byte values are specified as an ASCII string. The query form returns the current values.

Syntax :SOURce<slot>:DATA:SECTion:TRACe:VALUe:STRIng? :SOURce<slot>:DATA:SECTion:TRACe:VALUe:STRIng <String>

:SOURce:DATA:SOURce

This command sets the source of the data at the output of the OTS-9000 transmitter. The query form returns the current setting.

Syntax :SOURce<slot>:DATA:SOURce? :SOURce<slot>:DATA:SOURce <Enum>

Parameters	Description
INTErnal	The payload data comes from the internal test pattern generator
THRU	Through mode: the transmitted data comes from the receiver

:SOURce:DATA:SPE:BACKground:STUFfing

This command controls the SPE fixed byte stuffing in non-active STS-1 channels. When enabled, columns 30 and 59 of the background channels contain the fixed byte value zero and are not used for payload. This command is applicable when the background channel structure is set to STS-1. When disabled, columns 30 and 59 are part of the background payload. The query form returns the current setting. <Slot> is an optional number that specifies the module slot containing the device that is the target of the command; if omitted, it defaults to the lowest-numbered slot containing an applicable device.

Syntax :SOURce<slot>:DATA:SPE:BACKground:STUFfing? :SOURce<slot>:DATA:SPE:BACKground:STUFfing <Boolean>

3-56 OTS9100 User Manual