Reference: Remote Commands ~ Command Description

:SYSTem:COMMunicate:SERIal:COM2A:RTS

This command controls the state of the RTS (Request to Send) control signal on the COM2 port. It has no effect when hardware flow control is enabled. The query form returns the current setting.

Syntax :SYSTem:COMMunicate:SERIal:COM2A:RTS? :SYSTem:COMMunicate:SERIal:COM2A:RTS <Boolean>

:SYSTem:COMMunicate:SERIal:COM2A:RXTERM

This command selects, for the COM2 serial port, the character the OTS-9000 system recognizes as End- of-Input. The query form returns the current setting.

Syntax :SYSTem:COMMunicate:SERIal:COM2A:RXTERM? :SYSTem:COMMunicate:SERIal:COM2A:RXTERM <Enum>

Parameters

Description

LF

Line feed (LF) character, 0x0A; an optional preceding CR is ignored

CR

Carriage return (CR) character, 0x0D; an optional preceding LF is ignored

:SYSTem:COMMunicate:SERIal:COM2A:TXTERM

This command controls, for the COM2 serial port, the characters the OTS-9000 system sends at the end of a query response. The query form returns the current setting.

Syntax :SYSTem:COMMunicate:SERIal:COM2A:TXTERM? :SYSTem:COMMunicate:SERIal:COM2A:TXTERM <Enum>

Parameters

Description

LF

Line feed (LF) character, 0x0A

CR

Carriage return (CR) character, 0x0D

CRLF

CR followed by LF

LFCR

LF followed by CR

:SYSTem:CONFig:MODule:SERIAL

This query accepts a module slot number, between 1 and 16, and returns a string identifying the Tektronix module card serial number as a quoted string.

Syntax :SYSTem:CONFig:MODule:SERIAL? <NR1>

OTS9100 User Manual

3-75

Page 206
Image 206
Tektronix 071-0855-05 SYSTemCOMMunicateSERIalCOM2ARTS, SYSTemCOMMunicateSERIalCOM2ARXTERM, SYSTemCONFigMODuleSERIAL