Tektronix 071-0855-05 user manual 10 Gb/s TRANSMIT-ONLY Optics Card L5-15, L5-13

Optical Card Front Panel Descriptions

10 Gb/s TRANSMIT-ONLY OPTICS CARD

(L5-15, L5-13)

The 10Gb/s Optical Transmit-only card is available with two laser options:

1310 nm or 1550 nm. This Optics card performs E/O conversion and works in conjunction with the Transmit card, which contains transmitter functionality for the OTS9100 system.

Figure B-2 shows the Transmitter Optics card front panels.

Module OK

The Module OK LED should be green while the instrument is running. On power up, the LED first lights red, then changes to green when the system has finished initializing.

NOTE: If the LED remains red after the system has finished initializing or fails to light at all, call Tek service.

Optical OUT

The Optical Output emits an optical data signal at a wavelength of 1310 nm or 1550 nm, with the proper option. The optical connector can be configured with field interchangeable shells: FC(standard), ST, or SC type. The field interchangeable shells are easily removed to allow easy cleaning of the connector interface.

The LED located above the Optical OUT heading will flash amber for five seconds and then turn green when the laser is activated.

NOTE: If the LED flashes red, continues to flash amber, or fails to light at all, call Tektronix for service.

WARNING: Always avoid exposure to the laser beam. Before power is applied to the OTS9100 system, be sure that all laser outputs are either covered with the screw cap provided or connected to

the appropriate circuit.

Figure B-2:

Transmitter Front Panels

2-4 OTS9100 User Manual