Tektronix 071-0855-05 user manual SYSTemFILEsMGMTRESUltsENABle, SYSTemFILEsMGMTRESUltsINTErval

Reference: Remote Commands ~ Command Description

:SYSTem:FILEs:MGMT:RESUlts:ENABle

This command enables or disables each individual deletion trigger. During the current revisit interval the enable flags are polled, if an enabled criteria is met file deletion will begin and continue until all enabled criteria have been satisfied. Disabling the revisit interval flag will keep the system from deleting any files, while maintaining user-selected criteria. NOTE: The system requires a single numeric (base 10) parameter, flags are described as a bit field, the user must convert from the bit field (or hex) to a numeric integer. Flags are cumulative. Sending the value of zero disables all criteria.

Syntax: :SYSTem:FILEs:MGMT:RESUlts:ENABle? :SYSTem:FILEs:MGMT:RESUlts:ENABle <NR1>

Bit Value	Criteria affected
0x1	Enables (1) or disables (0) deletion based on number of files. Set by the COUNt
	command.
0x2	Enables (1) or disables (0) deletion based on total consumed space of files. Set by the
	TOTAlsize command.
0x4	Enables (1) or disables (0) deletion based on percentage of volume consumed. Set by the
	PERcent command.
0x8	Enables (1) or disables (0) deletion based on age of files (delta). Set by the AGE
	command.
0x10	Enables (1) or disables (0) the revisit interval. Set by the INTErval command.

:SYSTem:FILEs:MGMT:RESUlts:INTErval

This command sets the minimum amount of time the system waits between polling file deletion criteria. If any deletion criteria have been met, such as number of files, deletion will begin. If no criteria are met no deletion will take place until the next interval. The query form returns the current setting. NOTE: Units for INTErval are usec. Settings of less than 30000usec (30sec) should be avoided since constant revisits consume system resources. It is important to understand that this is a requested minimum interval, actual intervals are based on free CPU cycles.

Syntax: :SYSTem:FILEs:MGMT:RESUlts:INTErval? :SYSTem:FILEs:MGMT:RESUlts:INTErval <NR1>

:SYSTem:FILEs:MGMT:RESUlts:PERcent

This command sets the maximum percentage of disk volume that files are allowed to consume before deletion begins. The order in which files are deleted is based on the sort criteria, see the SORT command below. The query form returns the current setting.

Syntax: :SYSTem:FILEs:MGMT:RESUlts:PERcent? :SYSTem:FILEs:MGMT:RESUlts:PERcent <NR1>

3-78 OTS9100 User Manual