Operating Basics: Functional Overview

622 MHz TRIG OUT

The 622 MHz TRIG OUT provide a bit-rate/16 signal that may be used for triggering an oscilloscope to capture the 10 Gb/s Output signal. The output has an SMA connector and requires 50 Ohms termination for signal integrity.

Tx DATA OUT

Tx Data Output provides a DC-coupled CML output signal for interconnection between the module cards. This output must be connected to the Tx DATA IN connection found on the Optics card of the OTS9100 module using the coax cable provided.

Note: When connecting to an OTS91L1 card, a DC block must also be installed.

10 GHz CLOCK IN

The 10 GHz Clock IN is the bit-rate clock for the Tx Data Out interface. This input must be connected to the 10 GHz Clock Out port of the Clock Trigger card using the coax cable provided.

2-8

OTS9100 User Manual

Page 37
Image 37
Tektronix 071-0855-05 user manual MHz Trig OUT, Tx Data OUT, GHz Clock