Tektronix 071-0855-05 user manual SYSTemCOMMunicateNETWorkTXTERM, SYSTemCOMMunicatePORTECHO

Reference: Remote Commands ~ Command Description

:SYSTem:COMMunicate:NETWork:TXTERM

This command sets the initial selection, for new network connections, of the characters sent at the end of a query response. This setting has no effect on connections already established (see :SYSTEM:COMMUNICATE:PORT:TXTERM). The query form returns the current setting.

Syntax :SYSTem:COMMunicate:NETWork:TXTERM? :SYSTem:COMMunicate:NETWork:TXTERM <Enum>

Parameters	Description
LF	Line feed (LF) character, 0x0A
CR	Carriage return (CR) character, 0x0D
CRLF	CR followed by LF
LFCR	LF followed by CR

:SYSTem:COMMunicate:PORT:ECHO

The PORT commands affect the character-based remote control port (serial port or network connection) that receives the command; they are not valid for the GPIB. This command controls, for the current remote-control port, how the system echoes the characters it receives. The parameter is a numeric value containing three individual control bits. The query form returns the current setting.

Syntax :SYSTem:COMMunicate:PORT:ECHO? :SYSTem:COMMunicate:PORT:ECHO <NR1>

Bit value Function

0Disables echo

1Enables echo

2Causes the input terminator character to be echoed as CR-LF

4Enables input line buffering: received characters are not processed until the terminating CR or LF

:SYSTem:COMMunicate:PORT:PROMpt

This command enables or disables the user prompt on the current remote-control port. When the prompt is enabled, the system prompts when it is ready for a command. The query form returns the current setting.

Syntax :SYSTem:COMMunicate:PORT:PROMpt? :SYSTem:COMMunicate:PORT:PROMpt <Boolean>

OTS9100 User Manual 3-67