TOA Electronics C-DR161 CU Series Recording Setting, Priority REC Setting, Auto REC Setting

23. RECORDING SETTING

Priority recording and Auto-recording (Normal recording and Alarm Event recording) modes are available. In each recording mode, “Recording ON/OFF,” “Recording rate,” and “Picture quality” can be set for each camera. For the Digital Video Recorder, data from the start to the end of a recording is regarded as an event. (Refer to p. 38; Recording.)

R E C S E T	T I N G
P R I O R I T Y R E C S E T T I N G
A U T O R E C S E T T I N G
P R E – R E C S E T T I N G
O V E R W R I T E		O N

Item	Selection	Description
PRIORITY REC SETTING		For setting, refer to p. 77; Priority recording setting.
AUTO REC SETTING		For setting, refer to p. 79; Auto-recording setting.
PRE-REC SETTING		For setting, refer to p. 85; Pre-recording settings.
OVERWRITE	ON / OFF	Select whether or not to allow the overwriting of hard disk recordings.
		OFF: When all hard disks become full, recording is stopped to prevent older
		data from being replaced with new data. If the usable recording time is
		less than the Remaining Capacity Warning, the Disk Full LED will flash.
		(Refer to p. 93; System Settings) To begin recording again, initialize the
		hard disk. (Refer to p. 102; Hard Disk Drive Initialization.)
		ON: When all hard disks become full, previous recorded older images is
		automatically deleted and replaced with newer images.

Note: Underlined settings represent factory-preset settings.

76