TOA Electronics C-DR161 CU Series, C-DR091 CU Series operating instructions Settings of Groups a F

23.2.2. Settings of Groups A - F

Service operation methods of Groups A-F are set for each schedule. Set the camera alarm input and motion-detected modes and post time set in the Alarm Event Recording settings.

G R O U P – A S E T T I N G
N O R M A L R E C S E T T I N G
A L A R M E V E N T R E C S E T T I N G
A L A R M E V E N T R E C M O D E	S E Q U E N C E
A L A R M I N P U T M O D E	E D G E
P O S T A L A R M T I M E	9 9 9 S E C
M O T I O N D E T E C T M O D E	L E V E L
P O S T M O T I O N T I M E	1 S E C

Item		Selection	Description
NOMAL REC SETTING			For setting, refer to p. 81; Normal recording setting.
ALARM EVENT			For setting, refer to p. 82; Alarm event recording setting.
REC SETTING
ALARM EVENT	SEQUENCE / LAST		Sets the operation of alarm event recording when multiple alarm events
REC MODE			have occurred.
			SEQUENCE: Records all cameras set for alarm event. It is possible to
				set multiple alarm events for each camera, including up to
				four alarm inputs and four motion detection settings. *1 *2
			LAST:	Records only the camera that triggers alarm last. It is possi-
				ble to set one alarm input and one motion detection setting
				for each camera. *1
ALARM INPUT MODE		LEVEL / EDGE	Select either "Level" or "Edge" depending on the type of signal input to
			the Priority Recording Terminal. For information on recording operation
			when the Level or Edge mode is selected, see " Recording Operation
			When Edge/Level Settings Are Performed" on page 43.
POST ALARM TIME		0 - 60 - 999 SEC /	Set the length of time an Alarm Event recording is to continue after being
		NO LIMIT	triggered by an alarm input.
			0 - 999 SEC: Recordings are performed during the set post alarm time.
				If the alarm input mode is set to "Edge," the post alarm
				time can be set to 1 second or more. If it is set to "Level,"
				it can be set to 0 second or more. *4
			NO LIMIT: Recordings continue alarm recording completion until
				manually stopped.
MOTION DETECT		LEVEL / EDGE	Set the Motion Detection mode to either "Level" or "Edge." For information
MODE			on recording operation when the Level or Edge mode is selected, see
			" Recording Operation When Edge/Level Settings Are Performed" on
			page 43.
POST MOTION TIME		1 - 60 - 999 SEC /	Set the length of time an Alarm Event recording is to continue after being
		NO LIMIT	triggered by motion detection.
			1 - 999 SEC: Recordings are performed during the set post motion time. *4
			NO LIMIT: Recordings continue motion-detected recording completion
				until manually stopped.
Notes

·Underlined settings represent factory-preset settings.

·Default settings for Groups A - F are all identical.

*1 Even with the Sequence setting, if alarms are input in order, the last input screen is displayed.

*2 If multiple events are set, the camera with the lowest number is displayed on the full screen on the monitor.

*3 When multiple alarm-activated cameras are displayed on the full screen, the camera that triggered alarm last takes precedence.

*4 If post time is less than the recording rate, the image may not be played back correctly.

80