Toshiba B-SX6T, B-SX8T manual Printing Mode Selection, Dispensing Mode Selection, PRT Type no Tran

2. SYSTEM MODE

EO13-33002

2.1 Self-diagnostic Test

2.1.1 Printing Mode Selection

While “PRT TYPE TRANSFR” is displayed on the LCD, press the [PAUSE] key. The type of printing mode can be selected:

“TRANSFR” (Thermal transfer) or “DIRECT” (Thermal direct).

After selecting the printing mode to be used, press the [PAUSE] key.

[RESTART]

[FEED]

<1>DIAG. Vx.x

PRT TYPE TRANSFR

<1>DIAG. Vx.x

PRT TYPE NO TRAN

<1>DIAG. Vx.x

PRT TYPE DIRECT

Thermal transfer: When transparent ribbon is used.

Thermal transfer: When non-transparent ribbon is used.

Thermal direct: When thermal paper is used.

NOTE: When using the ribbon, be sure to select “Thermal Transfer”. When using the thermal media, be sure to select the “Thermal Direct”.

2.1.2 Dispensing Mode Selection

When “TYPE[S] NO CUT” is displayed, press the [PAUSE] key. The type of dispensing mode can be selected:

“[S] NO CUT” (Batch issue) or “[C] WITH CUT” (Cut issue)

After selecting the dispensing mode to be used, press the [PAUSE] key.

[RESTART]

[FEED]

<1>DIAG. Vx.x

TYPE[S] NO CUT

<1>DIAG. Vx.x

TYPE[C] WITH CUT

[S]NO CUT (Batch issue): To issue media in batch mode.

[C]WITH CUT (Cut issue): When an optional cutter module is installed.

NOTE: When using the cutter module, be sure to select “[C] WITH CUT”. When the cutter module is not installed, be sure to select “[S] NO CUT”.

2- 4