Toshiba B-SX6T, B-SX8T manual Maximum Number of Rfid Read Retries, Cycle CNT

2. SYSTEM MODE

EO13-33002

(Revision Date: Jul. 24, 2008)

2.9 RFID Module Setting

2.9.6Maximum Number of RFID Read Retries

This parameter is to set the maximum number of times to read an RFID tag.

If the printer does not succeed even if after having retried for the maximum number of times, the printer stops, resulting in an error (TIMEOUT). In case of frequent read errors, increase this retry count. However, when the retry count is increased, a data read may become slower.

If the specified time-out runs out, the printer stops retry even before the maximum number of retry times is reached. The printer always reads an RFID tag for a maximum number of retry times set by this parameter before writing data to the RFID.

When “R CYCLE CNT		5” is displayed, press the [PAUSE] key.
	<10>RFID
	R CYCLE CNT	5

Use the [FEED] or [RESTART] key to select a desired option. (Range: 0 to 255)

[RESTART]

[FEED]

R CYCLE CNT	255
R CYCLE CNT	3
R CYCLE CNT	2
R CYCLE CNT	1
R CYCLE CNT	0

[FEED] key: Pressing the [FEED] key one time causes a –1 change, up to 0.

[RESTART] key: Pressing the [RESTART] key one time causes a +1 change, up to 255.

After selecting the maximum number of read retries, press the [PAUSE] key.

2-78