Toshiba B-SX6T, B-SX8T manual Ribbon Type Selection, Strip Wait Status Selection

2. SYSTEM MODE

EO13-33002

2.2 Parameter Setting

After setting the control code for Control Code 1, press the [PAUSE] key to show the CONTROL CODE2 screen. In a same manner, press the [PAUSE] key after setting the control code for Control Code 2 to display the CONTROL CODE3 screen.

CONTROL CODE1

[PAUSE]

CONTROL CODE2

[PAUSE]

CONTROL CODE3

Press the [PAUSE] key after setting the control code for Control Code 3.

2.2.13 Ribbon Type Selection

This parameter is to choose a ribbon type to be used.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET RIBBON TRANS

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

RIBBON TRANS

RIBBON NON TRANS

Transparent ribbon Non transparent ribbon

After selecting a ribbon type, press the [PAUSE] key.

2.2.14 Strip Wait Status Selection

This parameter is to choose when the printer sends a strip wait status (05H) to a host in response to a status request command.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PEEL OFF STS OFF

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

PEEL OFF STS OFF

A strip wait status is sent when the printer receives the next issue command and the previously printed label is waiting to be removed.

[FEED]

PEEL OFF STS ON

A strip wait status is sent when a printed label is waiting to be removed.

After selecting the Strip Wait Status, press the [PAUSE] key.

2-26