Toshiba B-SX8T Control Code Selection, 2PARAMETER SET Code Auto, 2PARAMETER SET Control CODE1 1B

2. SYSTEM MODE

EO13-33002

2.2 Parameter Setting

3.The ribbon saving function is activated when there is a 20-mm or more non-print area in the media feed direction.

4.Ribbon saving is enabled up to 4 areas per media.

5.To use the ribbon saving function for more than one area in a label/tag, there should be at least an 8-mm print area between non-print areas where the ribbon saving is performed

2.2.12Control Code Selection

This parameter is to choose a Control Code.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET CODE AUTO

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

CODE AUTO

CODE ESC,LF,NUL

CODE{}

CODE MANUAL

Automatic selection

Manual selection

Manual selection

Control codes should be specified.

NOTES: 1. This parameter is used to select the Control Code for the communication between the printer and the host computer.

2. Selecting “Manual” enables you to set the control code.

When “CODE MANUAL” is selected and the [PAUSE] key is pressed, the LCD display will show the setting screen of CONTROL CODE1 to CONTROL CODE3 as follows.

<2>PARAMETER SET CONTROL CODE1 1B

[RESTART]

[FEED]

CONTROL CODE1 FF

CONTROL CODE1 FE

CONTROL CODE1 FD

CONTROL CODE1 02

CONTROL CODE1 01

CONTROL CODE1 00

NOTES: 1. Pressing the [FEED] or [RESTART] key causes 1-byte change in the Control Code value.

2.You cannot specify the same control code with the one used for the commands.

3.You cannot use the specified Control Code for the data of the Data Command or Display Command.

2-25