Descriptions of the Maintenance Counter

2. SYSTEM MODE

EO13-33002

(Revision Date: Jul. 24, 2008)

2.1 Self-diagnostic Test

• Descriptions of the Maintenance Counter

#	Item	Count Condition	Range
(1)	Total media distance	Counts when the feed motor is driven to feed, print or issue media.	0.0 to 3200.0 km
	covered	(Counted also during a reverse feed.) See NOTE 2.
(2)	Media distance	Destination printed on the same line indicates one selected for a	0.0 to 3200.0 km
	covered	parameter clear.
(3)	Print distance	Counts while printing. (Reverse feed is not counted.) See NOTE 3.	0.0 to 200.0 km
(4)	Cut count	Counts every cut. See NOTE 4.	0 to 1000000 times
(5)	Head up and down	Counts every head up and down cycle by means of the solenoid which	0 to 2000000 times
	cycle count	is used for the ribbon save function. See NOTE 4.
(6)	Ribbon motor driving	Counts when the ribbon motor is driven to feed, print or issue media.	0 to 2000 hours
	time	(The driving time is also counted during a reverse feed.) See NOTE 5.
(7)	Solenoid drive time for	Counts when the ribbon save function is activated. See NOTE 5.	0 to 1000 hours
	head up
(8)	RS-232C hardware	Counts when a parity, overrun or framing error occurs. See NOTE 6.	0 to 255 times
	error count
(9)	System error count	Counts when a system error occurs.	0 to 15 times
(10)	Momentary power	Counts when a momentary power interruption occurs.	0 to 15 times
	failure count
(80)	Number of successful	Counts when an RFID write has succeeded.	0 to 9999999 times
	RFID write
(81)	Number of failure in	Counts when an RFID write has failed.	0 to 9999999 times
	RFID write

NOTES:

1.Item from (2) through (10) are initialized to “0” after RAM clear.

2.If the media distance covered is 50.0 cm or less, it is rounded down and no data is added to the memory at power off.

3.If the print distance is 5.5 m or less, it is rounded down and no data is added to the memory at power off.

4.If the count is 31 or less, it is rounded down and no data is added to the memory at power off.

5.If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.

6.When a sent command results in an error, the same number as the data capacity of the command is counted by byte.

2- 7