Toshiba B-SX8T manual Rfid Read Retry Time-out, After selecting the time-out, press the Pause key

2. SYSTEM MODE

EO13-33002

(Revision Date: Jul. 24, 2008)

2.9 RFID Module Setting

2.9.7RFID Read Retry Time-out

This parameter is to set the time-out for retry to read an RFID tag.

If the printer does not succeed within the specified time-out, the printer stops, resulting in an error (TIMEOUT). In case of frequent read errors, increase the amount of time. However, when the amount of time is increased, a data read may become slower.

If the maximum number of retries is reached, the printer stops retry even before the specified time runs out. The printer always reads an RFID tag for the specified time set by this parameter before writing data to the RFID.

When “R CYCLE TIM		4.0” is displayed, press the [PAUSE] key.
	<10>RFID
	R CYCLE TIM	4.0

Use the [FEED] or [RESTART] key to select a desired option. (Range: 0.0 sec. to 9.9 sec.)

[RESTART]

[FEED]

R CYCLE TIM 9.9

R CYCLE TIM 4.0

R CYCLE TIM 3.9

R CYCLE TIM 0.0

[FEED] key: Pressing the [FEED] key one time causes a –0.1 change, up to 0.0.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 change, up to 9.9.

After selecting the time-out, press the [PAUSE] key.

2-79