Toshiba B-SX8T, B-SX6T manual Plug & Play Selection, Label End/Ribbon End Selection

2. SYSTEM MODE

EO13-33002

2.2 Parameter Setting

2.2.24 Plug & Play Selection

This parameter is to choose whether to enable a Plug & Play function.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PLUG & PLAY OFF

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

PLUG & PLAY OFF

PLUG & PLAY ON

Unavailable

Available

NOTE: If the printer and the PC are connected by USB, plug & play will be automatically enabled, regardless of the setting of this parameter.

After selecting a Plug & Play, press the [PAUSE] key.

2.2.25 Label End/Ribbon End Selection

This parameter is to choose a printing process when a label end or ribbon end is detected. For details, refer to NOTE on the following page.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET LBL/RBN END TYP1

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

LBL/RBN END TYP1

LBL/RBN END TYP2

TYPE1: When a label/ribbon end is detected in the middle of printing, printing is immediately paused.

TYPE2: When a label/ribbon end is detected in the middle of printing, the printer prints the half-finished label as far as possible, and stops when the next label is at the home position.

After selecting a Label End/Ribbon End type, press the [PAUSE] key.

2-31