Toshiba B-SX8T, B-SX6T manual Introduction, Key Operation Flow

1. INTRODUCTION

EO13-33002

(Revision Date: Jul. 24, 2008)

1.1 Key Operation Flow

1. INTRODUCTION

This document describes key operations using the keys and LCD display on the printer that you can operate on a printer alone. Key operations are performed in the following four printer setting modes:

•Online mode where a pause, reset, automatic threshold setting, etc. are performed.

•Download mode where a firmware downloading is performed.

•System mode for service personnel where a self-diagnosis, printer parameter settings, RAM clear, IP address setting etc. are performed.

•System mode for end user where a self-diagnosis, printer parameter settings, fine adjustment, etc., which are same functions as those in System mode for service personnel, are performed.

NOTE: This document uses the B-SX8T for examples of the display.

1.1 Key Operation Flow

Power OFF

Turn the power on.

Online mode

Online

[FEED] key

[PAUSE] key

Feeds one label.

[RESTART] key

Pause

Hold down the [PAUSE] key	Feed gap sensor automatic threshold setting
for a few seconds.	[FEED] key or [RESTART] key

Hold down the [RESTART] key	Black mark sensor threshold setting
for a few seconds.	• Reset
	• Parameter Setting
	• Fine adjustment
	• Dump mode
	• Expand mode (Basic expansion mode)
	• Automatic calibration mode
	• LAN Enable/Disable
	• RTC Setting

While holding down the [FEED], [RESTART], and [PAUSE] keys, turn the power on.

Download mode

While holding down the [FEED] and [RESTART] keys, turn the power on.

System mode for end users

• Self-test

While holding down the [FEED] and [PAUSE] keys, turn the power on.

System mode for service personnel

•Self-test

•Parameter setting

•Fine adjustment

•Test print

•Sensor adjustment

•RAM clear

•IP Address setting

•Basic setting

•For factory

•RFID Module Setting

• Parameter setting

• Fine adjustment

• Test print

1- 1