Toshiba B-SX6T, B-SX8T manual Coordinate Fine Adjustment

2. SYSTEM MODE

EO13-33002

2.3 Printer Parameter Fine Adjustment

NOTES:

1.The fine adjustment value equals to the sum of the fine adjustment values set by the PC command and this parameter. The maximum reverse feed amount fine adjustment value is +9.9 mm. When the value reached the maximum, the value remains unchanged even if the subsequent fine adjustment is performed.

2.There may be cases where a label is not returned to the home position depending on the print conditions, even if a reverse feed amount is the same as a forward feed amount.

When an operation including a reverse feed (cut issue, strip issue, forward feed standby after an issue) is performed using a sensor, a label/tag may not be returned to the home position resulting an error, if the label pitch length is almost the same as the distance between the thermal print head and the paper sensor (69.8 mm). To prevent this problem, the reverse feed amount should be increased by performing the reverse feed amount fine adjustment in the + direction.

2.3.4 X Coordinate Fine Adjustment

This parameter is to fine adjust the print position on X coordinate.

When “<3>ADJUST SET” appears, press the [PAUSE] key until the following display appears.

<3>ADJUST SET X ADJUST +5.0mm

Use the [FEED] or [RESTART] key to select a desired option. (Range: -99.9 mm to +99.9 mm)

[RESTART]

[FEED]

X ADJUST +99.9mm

X ADJUST +99.8mm

X ADJUST +0.1mm

X ADJUST +0.0mm

X ADJUST -0.1mm

X ADJUST -99.8mm

X ADJUST -99.9mm

[FEED] key: Pressing the [FEED] key one time causes a –0.1 mm change, up to –99.9 mm.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 mm change, up to +99.9 mm.

After completing the fine adjustment, press the [PAUSE] key.

2-42