Toshiba B-SX6T, B-SX8T manual Dump Mode, „ How to Perform a Dump Operation

3. ON LINE MODE

EO13-33002

(Revision Date: Jul. 24, 2008)

3.3 Dump Mode

3.3 Dump Mode

In dump mode, data in the receive buffer are printed. Data are expressed in hexadecimal values. This operation allows the user to verify programming commands or debug the program.

„How to Perform a Dump Operation

ON LINE

B-SX8T Vx.x

[PAUSE]

PAUSE 52

B-SX8T Vx.x

Press and hold the [RESTART] key for 3 seconds or longer.

<1>RESET

Press the [FEED] key until

<4>DUMP MODE is displayed.

<4>DUMP MODE

[PAUSE]

<4>DUMP MODE BUFFER RS-232C

[FEED] or [RESTART]

[PAUSE]

<4>DUMP MODE PRINT ON DEMAND

[FEED] or [RESTART]

*[PAUSE]

<4>DUMP MODE NOW PRINTING…

<4>DUMP MODE

Press the [PAUSE] key to stop printing.

The number of remaining print count

NOTE: When the [PAUSE] key is pressed during printing, the number of remaining print count is displayed.

Press the [PAUSE] key to enter the dump mode.

Choose a receive buffer to be dumped using the [FEED] or [RESTART] key.

•RS-232C: RS-232C receive buffer

•CENTRO: Centronics receive buffer

•NETWORK: Network interface receive buffer

•BASIC 1: BASIC interpreter (Interface → Interpreter buffer)

•BASIC 2: BASIC interpreter (Interpreter → Printer buffer)

• USB:	USB receive buffer
• RF-ID:	RFID receive buffer

Choose a printing method using the [FEED] or [RESTART] key.

•ON DEMAND: Prints 166 lines of data (approx. 50cm), then stops.

*To print the subsequent data, choose a printing method again and press the [PAUSE] key.

• ALL: Prints all data in the receive buffer, then stops.

The printer starts printing data in the receive buffer.

After all data has been printed, the display returns to <4>DUMP MODE.

Turn the power off, and then on.

ON LINE

B-SX8T Vx.x

3- 6