Toshiba B-SX6T, B-SX8T manual Sensor Type Selection, Printing Mode Selection, Issue Mode Selection

2. SYSTEM MODE

EO13-33002

2.4 Test Print

Sensor Type Selection

Select a sensor type among “TRANS” (Feed Gap Sensor), “REFLECT” (Black Mark Sensor) and “NONE”.

<4>TEST PRINT SENSOR TRANS.

[RESTART]

[FEED]

SENSOR NONE

SENSOR REFLECT.

SENSOR TRANS.

None

Black Mark Sensor

Feed Gap Sensor

After selecting a sensor type, press the [PAUSE] key to go to Printing Mode Selection.

NOTE: Select a sensor type which is proper for the media being used. Basically, the Reflective Sensor (Black Mark Sensor) is for tag paper, and the Transmissive Sensor (Feed Gap Sensor) is for label.

Printing Mode Selection

Select a printing mode for the test print among “TRANSFR” (Thermal transfer: transparent ribbon),

“NO TRAN” (Thermal transfer: non transparent ribbon), and “DIRECT” (Thermal direct).

<4>TEST PRINT PRT TYPE TRANSFR

		PRT TYPE TRANSFR
[RESTART]
		PRT TYPE NO TRAN
	[FEED]
		PRT TYPE DIRECT

Thermal Transfer: Transparent ribbon

Thermal Transfer: Non transparent ribbon

Thermal Direct

After selecting a printing mode, press the [PAUSE] key to go to Issue Mode Selection.

NOTE: Select a printing mode which is proper for the operating conditions. Basically, the Thermal Transfer is for the use of ribbon, and the Thermal Direct is for the use of thermal paper.

Issue Mode Selection

Select an issue mode for the test print among “[S]NO CUT” (Batch mode without cut), “[C]WITH CUT” (Cut mode), and “[H]PEEL OFF” (Strip mode).

<4>TEST PRINT TYPE[S]NO CUT

TYPE[S]NO CUT

[RESTART]

Batch mode without cut

[FEED]

TYPE[C]WITH CUT

TYPE[H]PEEL OFF

Cut mode

Strip mode

After selecting an Issue Mode, press the [PAUSE] key to go to Media Length Setting.

NOTE: Cut mode is available only when the optional cutter module (B-SX208-QM-R) is installed. Strip mode is available only when the optional strip module (B-SX908-H-QM-R) is installed.

2-50