Toshiba B-SX6T, B-SX8T How to Enter Test Print Mode, Media Ribbon Save Area 8 mm, 4TEST Print

2. SYSTEM MODE

EO13-33002

2.4 Test Print

How to Enter Test Print Mode

While pressing the [FEED] and [PAUSE] keys at the same time, turn on the printer. Hold both keys until the “<1>DIAG. Vx.x” Message appears.

<1>DIAG. Vx.x

Press the [FEED] key 3 times.

The Test Print is ready to be performed.

<4>TEST PRINT

NOTES: 1. When pressing the [FEED] and [RESTART] keys at the same time in the Test Print menu, the message returns to “<4>TEST PRINT”.

2.If holding the [FEED] or [RESTART] key for 0.5 seconds or longer in the Test Print menu, the key is entered continuously.

3.The fine adjustment parameters are effective for the Test Print. (except for X Axis Fine Adjustment.)

4.If any error occurs, an error message appears, and the printer stops printing. After clearing the errors, press the [PAUSE] key to return to the System Mode menu. The printer does not restart printing automatically.

5.A changed parameter becomes enabled by pressing the [PAUSE] key.

6.A label size greater than the image buffer length cannot be designated. If designated, the printer prints in the image buffer, or the printer stops because of an error.

7.The ribbon saving function automatically starts when the space area is as described below if the ribbon saving function parameter is set to ON and thermal transfer is selected for the printing mode:

•3”/sec: 20 mm or more

•4”/sec: 20 mm or more

•8”/sec: 30 mm or more

8.

9.

Media

T

E

C

Ribbon Save Area 8 mm

Ribbon Save Area

2-48