Toshiba B-SX6T, B-SX8T manual Head Up Cut Selection, Ribbon Save Function Selection

2. SYSTEM MODE

EO13-33002

2.2 Parameter Setting

NOTES: 1. If the printer is not used for a few days, the top edge of the media may become curly, which may cause a paper jam. The Auto Forward Wait Function prevents this problem since the media feed amount is increased so that the media stops past the platen.

2.When the Stop Position Fine Adjustment Value is set in + direction, the media will stop past the media outlet.

When the value is set in – direction, the media will stop inside the media outlet.

3.This setting will be useful to fine adjust the cut position of labels.

2.2.10Head Up Cut Selection

This parameter is to choose whether to activate the head up action in the cut issue.

This function prevents ribbon smudges by raising the print head during a reverse feed to the print start position.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET HEAD UP CUT OFF

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

HEAD UP CUT ON

HEAD UP CUT OFF

Activated

Not activated

After selecting the head up action in cut issue, press the [PAUSE] key.

NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R- QM-R) is installed

2. The print head may not be raised depending on the rise of the solenoid’s temperature.

2.2.11Ribbon Save Function Selection

This parameter is to choose whether to activate the Ribbon Saving function or not.

This function enables reducing the ribbon loss caused by taking up unused ribbon during non-print areas. When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET RBN SAVE ON (TAG)

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

RBN SAVE ON (TAG)

RBN SAVE ON (LBL)

RBN SAVE OFF

Activated (When the head lever is set to position 2.)

Activated (When the head lever is set to position 1.)

Not activated

After selecting the ribbon save function, press the [PAUSE] key.

NOTES: 1. For the B-SX6T, this function is available only when an optional ribbon saving module (B-SX908-R- QM-R) is installed.

2.If this parameter is set to ON without installing a ribbon saving module, the ribbon will be slack during paper feed or printing, and as a result, printing cannot be performed properly.

Also, be sure to conform the choice to the actual head lever position. Failure to do this may disable proper ribbon saving function.

2-24