104 GL-1010 Administrator’s Guide
RECOVERY UPDATE
The e-STUDIO GL-1010 Recovery CD-ROM is used to upgrade
or restore the operating system on the GL-1010 controller. There
are two ways to update the operating system:
nBoot the GL-1010 from the e-STUDIO GL-1010 Recovery
CD-ROM.
nPerform a OS Update from the copier control panel. This is
the recommended method of updating the OS software. The
controller performs a backup operation and saves the network
settings, which are then restored following the update.
This section provides procedures for performing each method of
Operating System update.
Update from Bootable CD-ROM
1Power up the e-STUDIO28/35/45 system.
2Immediately insert the e-STUDIO GL-1010 Recovery CD-
ROM into the drive. The flashing light on the CD-ROM drive
indicates the controller is trying to boot off of the CD. If this
light does not flash, leave the CD in the drive and reboot the
controller.
3Check the LCD Touch Screen on the copier. It displays the
following message as the controller boots off of the
CD-ROM:
Starting controller. Please wait.
NOTE:
If the Scan kit option is
installed, be sure to back up
the templates and
addressbook before
recovering or updating
controller software. They
are deleted during recover/
update process.