GL-1010 Administrator’s Guide 35
nIf the Infrastructure network type was selected, configure any
of the network protocols as needed
nIf the Ad Hoc network type was selected and the TCP/IP
protocol is to be used, select MANUAL
MSet the static IP address to 192.168.2.2, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0. The con-
necting client should have a IP address of 192.168.2.x
and same Subnet Mask and workgroup as the controller
10 Reboot the controller.
11 Perform a test print.
Troubleshooting
Enabling networking on both cards simultaneously
The embedded NIC is connected to the LAN and the wireless
NIC is configured for Ad Hoc (peer-to-peer).
1If the wireless NIC is already installed, go to step 6.
2Shutdown the Controller.
3Install the wireless NIC in Slot 1.
4Turn the controller on.
5Press FACTORY DEFAULT in the Admin tab of the copier front
panel and reboot the controller. Wait until the controller
prints a Startup Page before you continue.
6Configure the wireless networking on the Cisco card via the
ADMIN>WIRELESS SETTINGS button on the front panel.
nSelect NETBEUI and select DISABLE (press NO if asked to
reboot)