118 GL-1010 Administrator’s Guide
8From the NetWare Environment drop-down list, select the
applicable option:
M3.x Bindery (or 4.x Bindery Emulation) Mode
M4.x/5.x NDS Mode
M3.x and 4.x/5.x Mixed Mode.
9In the Print Server Name field, enter the name of the Print
Server you previously created. For example, GL_2_PS.
10 In the Printer Number field, enter the number assigned to the
printer you previously created. For Bindery mode, the
number is between 0 and 15; for NDS mode, the number is
between 0 and 254.
11 Scroll to the bottom of the page and then click Save.
12 Proceed to Installing Client Software on page 151.
PRINT SERVER MODE
Considerations and Limitations
nYou must enable the IPX/SPX protocol before you can run
the GL-1010 in Print Server mode.
nYou cannot attach any other printers to an GL-1010 running
in Print Server mode. This is contrary to the 255 printer limit
imposed by NetWare.
Prerequisites
Use the NetWare management utility PCONSOLE (for NetWare
3.x or 4.x Bindery Mode) or NWAdmin (NetWare 4.x or 5.x NDS
Mode) to perform the following steps prior to enabling Novell
print services through TopAccess.
If you have any questions about performing these steps, refer to
your Novell NetWare documentation.
1Create a new Print Server (PSERVER) on the Novell file
server.
2Create a new print queue (e.g., GL_2_Q).
3Create the printer (e.g., GL_2_PR) and select Other/Unknown
for the Printer Type.
4Assign the print queue to the printer.
NOTE:
When using NetWare
PCONSOLE version 4.x.x.,
toggle between NDS and
Bindery modes using the
F4 key.