GL-1010 Administrator’s Guide 37
nTo use APPLETALK, Select APPLETALK and select ENABLE (press
NO when asked to reboot)
nTo use TCP/IP, select MANUAL
MSet the static IP address to 192.168.2.2, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0. The con-
necting client should have a IP address of 192.168.2.x
and same Subnet Mask and workgroup as the controller
14 Reboot the controller.
15 Perform a test print for both the wired and wireless
configurations.
Uninstalling the wireless card and enabling the wired
networking
1Power down the controller.
2Remove the wireless NIC.
3Attach the network cable to the controller.
4Power up the controller.
5Press FACTORY DEFAULT in the Admin tab of copier front
panel and reboot the controller. Wait until the controller
prints a Startup Page before you continue.
6Configure the Networking on the controller via the
ADMIN>NETWORK SETTING button.
7Perform a test print.
Switching to wired networking without removing the
wireless card
1Attach the network cable to the controller.
2Disable wireless networking via the ADMIN>WIRELESS button
on the front panel.
nSelect NETBEUI and select DISABLE (press NO if asked to
reboot)
nSelect IPX/SPX and select DISABLE (press NO if asked to
reboot)
nSelect APPLETALK and select DISABLE (press NO when asked to
reboot)
nDisable TCP/IP