36 GL-1010 Administrator’s Guide
nSelect IPX/SPX and select DISABLE (press NO if asked to
reboot)
nSelect APPLETALK and select DISABLE (press NO when asked to
reboot)
nSelect TCP/IP and select MANUAL
MSet the static IP address to 0.0.0.0, Subnet Mask to
0.0.0.0 and Default Gateway to 0.0.0.0
7Configure Wi-Fi for Ad Hoc.
8Reboot the controller.
9Configure the wired networking on the controller via the
ADMIN>NETWORK SETTING button on the front panel.
nSelect NETBEUI and select ENABLE (press NO if asked to
reboot)
nSelect IPX/SPX and select ENABLE (press NO if asked to
reboot)
nSelect APPLETALK and select ENABLE (press NO when asked to
reboot)
nSelect TCP/IP and select MANUAL
MSet the static IP address to 192.168.2.1, Subnet Mask to
255.255.255.0 and Default Gateway to 0.0.0.0
10 Reboot the controller.
11 Configure the wired networking on the controller via the
ADMIN>NETWORK SETTING button on the front panel.
nSelect TCP/IP
MFor a fixed IP address, set a valid static IP address, Sub-
net Mask, Default Gateway, DNS and WINS servers
accordingly. If DHCP is desired, press DHCP
nIf desired, disable any of the other protocols as needed
12 Reboot the controller.
13 Configure the wireless networking on the Cisco card via the
ADMIN>WIRELESS SETTINGS button on the front panel.
nTo use NETBEUI, select NETBEUI and select ENABLE (press NO
if asked to reboot)
nTo use IPX/SPX, Select IPX/SPX and select ENABLE (press NO
if asked to reboot)