3 Tests and Diagnostics

3.24 SETUP

9.Configuration

This option lets you set the device configuration.

Setup by OS Operating system sets devices that it can control. (Default)

All Devices BIOS sets all devices.

NOTE: When using installed OS, selecting “Set by OS” is recommended. But, when setting “PC CARD-Controller Mode” to other than “ Auto-Selected”, select “ All Devices”.

10.DRIVES I/O

This option set the HDD, CD-ROM and PC card.

(a)Build-in HDD

Displays an address and interrupt level for the hard disk drive.

(b)PC Card

Displays an address and interrupt level for a PC card type of hard disk drive that can boot the computer, when the computer is booted by the drive.

11.PCI Bus

This option displays the interrupt level for the Card Bus in the computer. It is for information only and cannot be changed.

PCI BUS

= IRQ11

12.PC Card

This option displays the PC Card Controller mode. When “Device Config.” is set to “All Devices”, it can be changed.

Auto-Selected

Use this setting when OS supports Plug&Play. (Default)

Card Bus/16 bit

Use this setting when Cared Bus does not work properly in

 

“Auto-Selected” or PC card supports 16-bit.

PCIC

Use this setting when using a 16-bit PC card which does

 

not operate correctly in Auto-Selected or CardBus/16-bit.

3-70

PORTEGE R100 Maintenance Manual (960-440)

Page 160
Image 160
Toshiba R100 manual Drives I/O