4 Replacement Procedures 4.19 Fluorescent Lamp
4. Installing the bezel
1) Install the bezel to the left under the frame. (as shown in the figure below 1.)
2) Release the three latches at the bottom and apply the double-adhesive tape of
the bottom bezel to the cell. (As shown in the figure below 2.)
3) Set the left side bezel to the frame. (As shown in the figure below 3.)
4) Engage the two latches each of the left and light side bezel. (As shown in the
figure below 4.)
5) Engage the four latches at the top and apply the double-adhesive tape of the top
bezel to the cell. (As shown in the figure below 5.)
1) Be careful not to damage the cell, TAB and P/L.
Figure 4-47 Replacing Toshiba fluorescent lamp(9)
4-58 PORTEGE R100 Maintenance Manual (960-440)