4.19 Fluorescent Lamp | 4 Replacement Procedures |
5.Screwing the PCB and the bezel.
1)Use two screws to secure the left and right edge in the order of (1).
Caution: 1) The screw tightening torque is 0.167N·m(1.7kgf·cm) for all screws.
2)Use a Philips screwdriver with type 0 bit.
6.Installing the tapes and insulation sheets.
1)Apply the double- adhesive tape of the insulation sheet.
Caution: 1) Refer to the figure below.
2)When sticking the insulation sheet, be careful not to damage the PCB, cell and B/L.
Figure 4-48 Replacing Toshiba fluorescent lamp(10)
PORTEGE R100 Maintenance Manual |
