Toshiba R100 manual Replacing the 12.1 Inch Toshiba Matsushita Fluorescent Lamp

4.19 Fluorescent Lamp 4 Replacement Procedures

4.19.1Replacing the 12.1 Inch Toshiba Matsushita Fluorescent Lamp

The following describes the procedure for replacing the fluorescent lamp (See Figures 4-40 to 4-49).

Disassembling the module.

1.Peel off tapes and insulating sheets.

1)Carefully place the module face up on a clean and flat worktable. To avoid scratching the face of the LCD module, make sure the table is free of dirt and dust. Place a protection sheet (soft cloth or similar item) over the front of the module.

2)Remove the items indicated by the diagonal line in the figure.

Caution: 1) Be careful not to damage the TAB, PCB, B/L and reflection sheet.

2)Leave the insulation sheet on the bezel to reuse later.

3)When peeling off the double-adhesive tape of the insulation sheet, be careful not to damage the TAB and PCB.

Figure 4-40 Replacing Toshiba fluorescent lamp(1)

PORTEGE R100 Maintenance Manual (960-440) 4-51