4 Replacement Procedures

4.7 Touch pad

4.7Touch pad

Removing the Touch pad

The following describes the procedure for removing the touch pad. (See Figure 4-13.)

1.Disconnect the cable from the connector PJ334 on the system board.

2.Release the latches and remove the touch pad holder.

3.Remove the following screws and remove the touch pad.

• M2⋅2.5BS Special HEAD screw x3

Figure 4-13 Removing the touch pad

Installing a touch pad

The following describes the procedure for installing a touch pad. (See Figure 4-13.)

1.Apply the touch pad fitting to the guide.

2.Secure the touch pad with the following screws.

• M2⋅2.5BS Special HEAD screw x3

3.Install the touch pad holder.

4.Connect the cable to the connector PJ334 on the system board.

4-22

PORTEGE R100 Maintenance Manual (960-440)

Page 191
Image 191
Toshiba R100 manual Removing the Touch pad, Installing a touch pad