
Getting Started | User Guide |
|
|
Use the included Camera Cable (8 ft. standard Ethernet cable) to connect the power supply to the camera.
Note: The Camera Power Supply has
Outdoor Camera Instructions
a. Select a location for the camera.
The starter and
b. Plug the camera into a nearby outlet.
Spy Camera Instructions
a. Select a location for the camera.
The Spy Camera can be placed anywhere on a flat surface that has an unobstructed field of view. It looks natural wherever you place it – on a
b. Plug the camera into a nearby outlet.
STEP 2 – IDENTIFY THE NEW CAMERA IN COMMAND CENTER
There are two choices of setup paths – a and b. So, read both before moving on with the procedure:
a. You did NOT set a custom password
If you have NOT set a custom camera password, then you do not need to do anything more. Command Center will automatically recognize the camera within
Once the camera appears, you can change its configuration, set a name, or adjust the picture options. (See the chapter on Setting System Options for information on these settings.)
b. You did set a custom password
If you HAVE set a custom camera password, you need to complete a few additional tasks. This is necessary because new cameras are shipped with no password (different from the custom password you have set). Therefore, Command Center will not automatically identify it.
Follow these instructions to include the new camera into your Command Center system:
1)Go to the Command Center > Setup > Advanced dialog screen.
2)Click the FIND MY CAMERAS button.
3)Follow the instructions in the Find My Cameras Wizard.
Note 1: We recommend that you set a custom password because a custom camera password provides you with security from others having access to your streaming video.
Note 2: If you receive a camera from a friend or as a used item, it may have a password stored on its power supply. This will prevent you from linking with the camera. To remove the password, power up the Indoor camera and wait until the camera’s top two green status lights are flashing. Then with the end of the paper clip, gently press the reset button hidden below the reset hole near the Ethernet cable plug.
After the camera resets, it will have no password. If necessary, you may need to repeat the steps above to connect the Indoor camera.
15