Xerox P12 manual Printer Status Definition/Cause Action

Printer Status	Definition/Cause	Action
Diagnostic	Indicates that the Xerox DocuPrint P12
Processing	controller hardware is being tested by a
	diagnostic program. When Xerox
	DocuPrint P12 enters this status, all LEDs
	turn on for approximately 1 second then
	blink for 3 seconds. After this, the printer
	will begin RAM size checking and clearing
	the memory, at this time, all LEDs will
	turn on.
Initializing	Indicates that the printer is first started up	Refer to the table on page 55.
	or that the printer is resetting. If the
	printer engine is not yet warmed up when
	the initialization is finished, Xerox
	DocuPrint P12 waits for the engine to
	warm up with the In use LED response.
Ready	Indicates that the printer is ready to
	execute a print job from the
	communication channel. In this status,
	pressing the control panel button takes
	the printer off-line (Pause/Off-line).
In use	Indicates that the printer is processing a
	print job. Pressing the control panel
	button pauses/resumes a print job. This
	is also used to indicate that the printer is
	warming up.
Waiting for data	Indicates the printer has received wrong	Press the button. If the PCL
	data. Or the printer is waiting for a PCL	job is not sent, it will be
	form feed command.	canceled.

56• Chapter 4