Avaya AP-6, AP-4, AP-5 manual Set up Automatic Configuration for Static IP

Management

configured for static IP, these parameters are instead configured in the AP interface.

After setting up automatic configuration you must reboot the AP. When the AP reboots it receives the new configuration information and must reboot one additional time. If Syslog is configured, a Syslog message will appear indicating the success or failure of the Automatic Configuration.

Set up Automatic Configuration for Static IP

Perform the following procedure to enable and set up Automatic Configuration when you have a static IP address for the TFTP server.

1.Click Configure > Management > AutoConfig. The Automatic Configuration Screen appears.

2.Check Enable Auto Configuration.

3.Enter the Configuration Filename.

4.Enter the IP address of the TFTP server in the TFTP Server Address field.

NOTE:

The default filename is config. The default TFTP IP address is “169.254.128.133” for the AP.

5. Click OK to save the changes.

Avaya Wireless AP-4/5/6 User’s Guide 4-77