Avaya AP-4, AP-5, AP-6 - page 340

Recovery Procedures
7-24 Avaya Wireless AP-4/ 5/6 User’s Guide
Setting IP Address using Serial Port
Use the following procedure to set an IP address over the serial port
using the CLI. The network administrator typically provides the AP IP
address.
Hardware and Software Requirements
• Standard straight-through serial data (RS-232) cable with a one
male DB-9 connector and one female DB-9 connector. The AP
comes with a female 9-pin serial port.
• ASCII Terminal software, such as HyperTerminal.
Attaching the Serial Port Cable
1. Unlock and remove the cable cover from the AP.
2. Remove the front cover from the AP to reveal the serial port.
3. Connect one end of the serial cable to the AP and the other end to
a serial port on your computer.
4. Power on the computer and AP, if necessary.