Recovery Procedures

! CAUTION:

By completing Step 2, the firmware in the AP will be erased. You will need an Ethernet connection, a TFTP server, and a serial cable (if using the Bootloader CLI) to reload firmware.

2.Press and hold the RELOAD button for about 20 seconds until the POWER LED turns amber.

Result: The AP deletes the current AP Image.

3.Follow one of the procedures below to load a new AP Image to the Access Point:

Download a New Image Using ScanTool

Download a New Image Using the Bootloader CLI

Download a New Image Using ScanTool

To download the AP Image, you will need an Ethernet connection to the computer on which the TFTP server resides and to a computer that is running ScanTool (this is either two separate computers connected to the same network or a single computer running both programs).

ScanTool detects if an Access Point does not have a valid software image installed. In this case, the TFTP Server and Image File Name parameters are enabled in the ScanTool’s Change screen so you can download a new image to the unit. (These fields are grayed out if ScanTool does not detect a software image problem.)

7-18

Avaya Wireless AP-4/5/6 User’s Guide

Page 334
Image 334
Avaya AP-6, AP-4, AP-5 manual Download a New Image Using ScanTool