Recovery Procedures

4.Open your terminal emulation program (like HyperTerminal) and set the following connection properties:

Com Port: <COM1, COM2, etc., depending on your computer>

Baud rate: 9600

Data Bits: 8

Stop bits: 1

Flow Control: None

Parity: None

5.Under File -> Properties -> Settings -> ASCII Setup, enable the Send line ends with line feeds option.

Result: HyperTerminal sends a line return at the end of each line of code.

6.Press the RESET button on the AP.

Result: The terminal display shows Power On Self Tests (POST) activity. After approximately 30 seconds, a message indicates: Sending Traps to SNMP manager periodically. After this message appears, press the ENTER key repeatedly until the following prompt appears:

[Device-Name]>

7-22

Avaya Wireless AP-4/5/6 User’s Guide

Page 338
Image 338
Avaya AP-5, AP-4, AP-6 manual Device-Name