Recovery Procedures
Avaya Wireless AP-4 /5/6 User’s Guide 7-27
network, you should not need to manually configure the
Access Point’s IP address; the Access Point will obtain an IP
address from the network’s DHCP server during boot-up.
Result: After each entry the CLI reminds you to reboot; however
wait to reboot until all commands have been entered.
[Device-Name]> set ipaddrtype static
[Device-Name]> set ipaddr <IP Address>
[Device-Name]> set ipsubmask <IP Subnet Mask>
[Device-Name]> set ipgw <Default Gateway IP Address>
[Device-Name]> show ip (to confirm your new settings)
[Device-Name]> reboot 0
7. After the AP reboots, verify the new IP address by reconnecting to
the CLI and enter a show ip command. Alternatively, you can ping
the AP from a network computer to confirm that the new IP
address has taken effect.
8. When the proper IP address is set, use the HTTP interface or CLI
over Telnet to configure the rest of the unit’s operating parameters.