Configure Multiple SSID/VLAN/Security Mode Entries

NOTE:

The ability to configure up to 16 VLAN/SSID pairs and configure a security mode per SSID is available only for the AP-6, and APs that have an 802.11a/b/g or 802.11b/g Upgrade Kit installed.

The four primary scenarios for using VLAN workgroups are as follows:

1.VLAN disabled: Your network does not use VLANs, but you can configure the AP to use multiple SSIDs.

2.VLAN enabled, all VLAN Workgroups use the same VLAN ID Tag

3.VLAN enabled, each VLAN workgroup uses a different VLAN ID Tag

4.VLAN enabled, a mixture of Tagged and Untagged workgroups

Configure Multiple SSID/VLAN/Security Mode Entries

Each SSID/VLAN can have its own security mode, so that customers can have multiple types of clients (non-WEP, WEP, 802.1x, WPA) on the same system, but separated by VLAN.

NOTE:

You must reboot the AP before any changes to these parameters take effect.

1.Click Configure > SSID/VLAN/Security > Mgmt VLAN.

Avaya Wireless AP-4/5/6 User’s Guide

4-137

Page 235
Image 235
Avaya AP-6, AP-4, AP-5 Configure Multiple SSID/VLAN/Security Mode Entries, Click Configure SSID/VLAN/Security Mgmt Vlan