Avaya AP-6, AP-4, AP-5 manual Additional Hardware Features

Additional Hardware Features

6.Remove the front cover from the unit. See Remove the Front Cover for an illustration.

7.Remove the back cover from the unit. See Remove the Back Cover for an illustration.

8.Place the back cover on the mounting location and mark the center of the three mounting holes.

9.Remove the cover from the wall and drill a hole at each of the locations you marked above. Each hole should be wide enough to hold a mounting plug (which is 6 mm x 35 mm).

10.Insert a plug into each hole. The AP comes with four 6 mm x 35 mm plugs; you only need to use three of these when wall mounting the unit.

11.Insert a screw into each of the mounting holes molded into the back cover. The AP comes with four 3.5 mm x 40 mm pan-head screws; you only need to use three of these when wall mounting the unit.

12.Insert the screws into the wall plugs. Use a screwdriver to tighten the screws and attach the back cover to the wall. In the following example, the back cover is mounted upside down (the two holes are at the bottom).

Avaya Wireless AP-4/5/6 User’s Guide 2-49