Avaya AP-4, AP-6, AP-5 manual RAD Configuration Requirements

Configure Multiple SSID/VLAN/Security Mode Entries

RAD Configuration Requirements

The RAD feature can be configured/monitored via the HTTP, CLI, or SNMP management interfaces.

The following management options are provided:

•The RAD feature can be enabled or disabled.

•The repetition interval of RAD can be configured.

•SNMP Traps are sent after completion of a RAD scan cycle and also whenever a new Access Point is detected.

•Additionally, the RAD scan results are maintained in a table that can be queried via SNMP. The system administrator has to enable RAD on the Access Points in the wireless network and also configure the Trap Host on all these Access Points to the IP address of the management station. The Access Points on detecting a new Access Point sends a RAD Scan Result Trap to the management station.

Avaya Wireless AP-4/5/6 User’s Guide 4-151