Avaya AP-5, AP-4, AP-6 manual Initializing the IP Address using CLI

Recovery Procedures

Initializing the IP Address using CLI

After installing the serial port cable, you may use the CLI to communicate with the AP. CLI supports most generic terminal emulation programs, such as HyperTerminal (which is included with the Windows operating systems). In addition, many web sites offer shareware or commercial terminal programs you can download. Once the IP address has been assigned, you can use the HTTP interface or the CLI over Telnet to complete configuration.

Follow these steps to assign the AP an IP address:

1.Open your terminal emulation program (like HyperTerminal) and set the following connection properties:

—Com Port: <COM1, COM2, etc., depending on your computer>

—Baud rate: 9600

—Data Bits: 8

—Stop bits: 1

—Flow Control: None

—Parity: None

2.Under File -> Properties -> Settings -> ASCII Setup, enable the Send line ends with line feeds option.

Result: HyperTerminal sends a line return at the end of each line of code.

Avaya Wireless AP-4/5/6 User’s Guide 7-25