
5. System Setup
Output Setup
lìíéìí=pÉíìé
Please note the following important output setup prerequisite:
•Ensure that you know your projector’s native resolution. Refer to your projector’s technical manual for details.
Use the following steps to set up the
Note | The |
| projector’s native resolution. |
|
|
1.From the Home Menu, press {OUTPUT} to access the Output Menu.
2.On the Format line, select your projector’s native resolution, and a frame rate that is consistent with your inputs.
S Example: If you are using 59.94 NTSC video inputs, run the output at the same rate in order to be synchronous.
In Appendix A, refer to the “Input and Output Resolutions“ section on page 129 for details on all available resolutions.
3.After selecting a format, press {SELECT FORMAT} to “accept” the selection.
4.Press {SAVE} to save all output settings in the output file.
Please continue with the “Projector Setup” section on page 88.
mêçàÉÅíçê=pÉíìé
Please note the following important projector setup prerequisite:
•Ensure that you are familiar with the Output Setup Menu and all sub menus included on that screen. In Chapter 4, refer to the “Output Menu Functions” section on page 40 for details.
Use the following steps to set up your projector.
1.From the Home Menu, press {OUTPUT} to access the Output Menu.
2.Press {TEST PATTERN} to access the Test Pattern Menu.
a.Scroll to the Type line and select the Burst test pattern.
b.Scroll to the Raster Box line and enable the Raster Box.
c.At the projector itself, perform the following adjustments to ensure that the
•
•
Note
Adjust the image for a minimum amount of noise
Adjust the image such that the entire Raster Box is visible.
Refer to your projector’s technical manual for information on all projector setup and adjustment procedures.
d.Once the projector is properly set, disable the Raster Box and select the 100% Color Bars test pattern.
88 |
|
|
|